Automate teacher evaluation Template using Fit3D Bot

Discover a no-code way to develop fully-automated teacher evaluation workflow with Fit3D bot

• To begin developing a new automated teacher evaluation workflow, navigate to the dashboard and click Start. Choose Design workflow and upload your document or create it from scratch.

  

• After a document is uploaded or imported, you can add fillable fields to modify it. Place fields where you need it in a document to make it easier for recipients to complete.

  

• After you’ve uploaded or created teacher evaluation, the next stage is assigning this document along with its fields to recipients.

  

• Next, proceed to the Assign fields dropdown to indicate which document fields are created for which users.

  

• Once done, click Continue at the bottom of the screen.

  

• The final stage of configuring an automated teacher evaluation workflow is adding the no-code bots. To add a Fit3D bot to the step, hover over the step you want to automate and choose the Add bot to step option.

  

• At this stage, the list of available bots is limited. Choose All bots in the top left corner to see the full list of the bots you can add to the step. Alocate the Fit3D bot, click Install bot, and configure the bot configurations.

  

• Now that your automated teacher evaluation workflow is configured, you can:

  • check how it works by choosing Test
  • click Finish later if you plan to go back to the workflow setup
  • click Publish to send out your workflow